Print steps

Wall Mount installation

Before you begin: First remove the stand cover.

Steps

1. Use a Philips head screwdriver to tighten the two brake screws for the sliding hinges while the stand is still attached. Be careful not to overtighten the screws.
2. The wall mount adapter plate is attached to the bottom of the stand with four screws. 
3. Remove the screws and pull off the wall mount plate.
4. Detach the four screws for the stand.
5. Remove the stand.
6. There are cutouts on the wall mount plate that fit over rails on the hinge slider.
7. To install the wall mount adapter plate, align the holes over the rails and press to secure.
8. Use the four screws that attached the wall mount adapter plate to the stand to secure the plate to the hinge sliders.
9. Slide the wall mount plate up to lock it into position.
10. If the wall mount will not slide, then remove the wall mount bracket and loosen the brake screws.
11. The VESA compatible wall mount hardware may now be installed onto the adapter plate according to manufacturer instructions.

Wall Mount removal

Steps

1. The wall mount adapter plate, if installed, must be removed to access most system components.
2. To remove the wall mount adapter plate, first remove the four screws securing the wall mount plate to the hinge sliders.
3. Pull off the wall mount plate.
4. Loosen the two Philips head brake screws.
5. Shift up each hinge slider to release it from its locked position, then slide it down to its bottommost position on the unit.
6. Tighten the brake screws.